hp5225提示59F0錯誤
更新時間：2025/5/13 2:49:17,view:172蘇州hp5225打印機售后服務中心客服熱線69616769，蘇州hp打印機售后維修電話，hp打印機售后網點，hp5225 打印機,主板錯誤代碼, PCLXLerror, 打印機報代碼59.c0, 報代碼60.02故障, 恢復默認設置, 代碼59.3錯誤, 出現(xiàn)定影器錯誤, turnoff.reinstall, turn off itb, 打印機顯示10.90531, 代碼10.9531錯誤, Hpdn廢粉倉在哪里, 報錯10.9531, 部分文字缺失,5225維修視頻2025/5/13
電機和齒輪組轉不動都會出現(xiàn)59.F0,蘇州惠普售后維修電話696l6769
The sensor flag/lever is stuck in the up position which causes the 59.F0 error
59.F0 error ITB Contact Alienation error
Code 59.F0
Display
59.F0 ERROR
Description Transfer alienation failure
Remedy
1. Verify that the ITB is installed.
2. Reconnect the primary-transfer disengagement sensor J19, and connector J128 on the DC controller PCA .
3. Run the sensor test in the sensor monitor mode to verify that the primary transfer disengagement sensor is functioning properly. If not, replace the primary transfer disengagement sensor.
4. Perform the alienation drive component test in the DIAGNOSTICS menu. If not, replace the fuser motor.
The following are the steps to be performed to solve 59.F0 error code.
Step 1: Reseat ITB
The first step is to reseat the Intermediate Transfer Belt (ITB).
Step 2: Check Connection of sensor SR9.
Next check the connection to sensor SR9. This sensor controls the Primary Transfer Roller Disengagement and is connected at the Connector J19. Also check the connections to the DC controller.
Step 3: Manually check the ITB gear and Flag.
hp5225提示59F0錯誤
The sensor flag/lever is stuck in the up position which causes the 59.F0 error
59.F0 error ITB Contact Alienation error
Code 59.F0
Display
59.F0 ERROR
Description Transfer alienation failure
Remedy
1. Verify that the ITB is installed.
2. Reconnect the primary-transfer disengagement sensor J19, and connector J128 on the DC controller PCA .
3. Run the sensor test in the sensor monitor mode to verify that the primary transfer disengagement sensor is functioning properly. If not, replace the primary transfer disengagement sensor.
4. Perform the alienation drive component test in the DIAGNOSTICS menu. If not, replace the fuser motor.
The following are the steps to be performed to solve 59.F0 error code.
Step 1: Reseat ITB
The first step is to reseat the Intermediate Transfer Belt (ITB).
Step 2: Check Connection of sensor SR9.
Next check the connection to sensor SR9. This sensor controls the Primary Transfer Roller Disengagement and is connected at the Connector J19. Also check the connections to the DC controller.
Step 3: Manually check the ITB gear and Flag.
hp5225提示59F0錯誤
熱門圖文