打印機發生錯誤代碼H4-01
更新時間：2025/7/17 22:52:16,view:599蘇州夏普401打印機售后服務中心客服熱線69616769，蘇州夏普打印機售后維修電話，夏普打印機售后網點，夏普401SHARPAR-8故障代碼L1怎么處理,ar-8太陽燈紅,ar-8解除三角形紅燈,AR-8預熱慢,請問AR-8復印機怎么突然復印打印不了?,ar-8載體更換,ar-8顯示f2如何清除?,AR-8復印文件出現一個位置老是白色的,ar-8如何拆硒鼓,AR-8剛剛換載體打印出來中間是白的,SHARPar-8硒鼓重置,ar-8換粉盒后打印出來是白紙,SHARPAR-8復印機出現F5是什么問題,AR-8打印機三角符號燈亮是什么意思?,AR-8H2變換,401維修視頻2025/6/26
打印機發生錯誤代碼H4-01
夏普276 鄭乖竣 2018/11/8 21:04:08 H4-01Code H4-01
Description Sub heater lamp abnormally low temperature detection
The setup temperature (about 90°C) is not reached within the specified time (about
17sec) from turning on the power ON SW. (When the temperature of sub heater thermistor falls below 140°C in the standby mode or printing.) Whether temperature of sub heater lamp thermistor falls below 50°C in the pre-heat mode.
Causes Sub heater lamp thermistor defect Sub heater lamp failure Sub thermostat failure Control PWB failure
Remedy Check the sub heater lamp blinking with SIM
5-2-2. When the lamp blinks normally: Check the thermistor and the harness. Check the MCU PWB thermistor input circuit. When the lamp does not light: Check for disconnection of the heater lamp and thermostat. Check the interlock switch. Check the power PWB and the MCU PWB lamp control circuit. Clear the display of self-diagnostics with SIM14.
夏普276 鄭乖竣 2018/11/8 21:04:08 H4-01Code H4-01 Description Sub heater lamp abnormally low temperature detection
The setup temperature (about 90°C) is not reached within the specified time (about
17sec) from turning on the power ON SW. (When the temperature of sub heater thermistor falls below 140°C in the standby mode or printing.) Whether temperature of sub heater lamp thermistor falls below 50°C in the pre-heat mode.
Causes Sub heater lamp thermistor defect Sub heater lamp failure Sub thermostat failure Control PWB failure
Remedy Check the sub heater lamp blinking with SIM
5-2-2. When the lamp blinks normally: Check the thermistor and the harness. Check the MCU PWB thermistor input circuit. When the lamp does not light: Check for disconnection of the heater lamp and thermostat. Check the interlock switch. Check the power PWB and the MCU PWB lamp control circuit. Clear the display of self-diagnostics with SIM14.
熱門圖文