震旦369s輸稿器卡紙,清潔過adf傳感器了頻繁報6601660566
更新時間：2025/6/22 23:39:49,view:86震旦打印機369s蘇州震旦打印機售后服務中心客服熱線69616769，蘇州震旦售后電話，震旦售后網點， 震旦ad369s維修密碼, 震旦Ad369s感光鼓單元, 震旦369s報C-D262,維修視頻
維修手冊,故障代碼,技術通報
·Code: 6610 定影出錯,感應器未開啟
Description:
The fuser pressure release error The fuser release sensor does not turn on, off, after 30 s from starting pressurization, depressurization operation.
Remedy:
Fuser unit 1. Check there is no paper jam.. 2. Check if the fuser pressure can be reduced by inverse rotation of the fuser gear by hand. 3. Check if the Press-release sensor light is blocked out by the actuator during depressurization operation. 4. Confirm that the wiring connector is firmly connected,,if necessary, connect the connector all the way in. Fuser unit (Press-release sensor),Eject PWB (YC2) Eject PWB (YC1),Main/Engine PWB (YC11) 5. If the wiring is disconnected, short-circuited, has ground fault, replace the wire. 6. Replace the fuser unit.
Fuser motor 1. Check if the fuser motor is rotating. 2. When turning the power on, check if the fuser motor rotates reversely. 3. Confirm that the wiring connector is firmly connected,,if necessary, connect the connector all the way in. Fuser motor,Engine relay PWB (YC20) 4. If the wiring is disconnected, short-circuited, has ground fault, replace the wire. 5. Replace the fuser motor.
Eject PWB Replace the eject PWB.
Engine relay PWB Replace the engine relay PWB.
Main/Engine PWB 1. Check the engine firmware,upgrade to the latest version if necessary. 2. Replace the Main/Engine PWB.
Main/Engine PWB 1. Unplug the power cord from the wall outlet,,wait five seconds. Then plug the power cord,then turn on the power switch. 2. Check if the Main/Engine PWB is properly secured with screws. (Grounding check) 3. Check that the connectors on the Main/ Engine PWB are properly connected,,if not, re-connect them. 4. Check the engine firmware,upgrade to the latest version if necessary. 5. Replace the Main/Engine PWB. 企業一站式服務，上門維修，耗材配送
熱門圖文