久久婷婷综合色丁香五月,91久久综合一区二区三区桃色,亚欧一区不卡久久,国内永久免费crm系统网站,91九色麻豆,亚偷熟乱区综合一区二区在线,天天日天天色天天操,91精品国产自产91精品资源,欧日美韩视频网站C0m,久久99国产精品片久久99蜜桃,波多野结衣网站,A级无遮挡超级高清在线观看,免费视频91,国精产品一二三区区别在哪,久久无限看,51爱久久网,欧美日韩B区

ÌKÖÝcanon´òÓ¡™C¾SÐÞ·þ„Õ¾W> ¾SÐÞÙYÁÏ > canon > ÌKÖÝcanonÊÛºó·þ„ÕëŠÔ’696l6769 > ÕýÎÄ

CanonIR2220iErrorcodeE355andE350

¸üЕrég£º2025/6/24 12:31:02,view:103

canon´òÓ¡™CCanonIR2220iErrorcodeE355andE350ÌKÖÝcanon´òÓ¡™CÊÛºó·þ„ÕÖÐÐĿͷþŸá¾€69616769£¬ÌKÖÝcanonÊÛºóëŠÔ’£¬canonÊÛºó¾Wüc£¬¾SÐÞÒ•îl

Canon IR 2220i Error code E355 and E350

Problems in the main controller area.
The E355 error code is due to no communication between the Main-Controller board and the Serial Number board below it. The boards are connected by a 11 PIN yellow connector and cable. This yellow connector must be reseated on the new Main-Controller board when changed. The connector must be seated firmly on the board.


When this error occurs, you must go into Service Mode and clear the error code.
How to clear the error code:
1. Enter Service Mode: Press * Additional Functions, 2&8 simultaneously, then * Additional Functions again.
2. Then select the [COPIER] option. Under [COPIER], select the Function tab.
3. Under the [FUNCTION] tab, select the [CLEAR] option.
4. In [CLEAR] there is a selection E355-CLR. Select it and hit OK.
5. Reboot the machine.
If the error occurs again:
1. Make sure the connection is secure and tight to the Main-Controller board from the connector cable to the Serial Number board below.
2. Reseat the Main-Controller board into its slot.
3. Go into service mode and clear the error code as explained above.
* If the error still continues, you probably have a bad Serial Number board and it needs to be replaced.

E350 is soft ID PCB Faulty and E355 is counter pcb problem. Have you cleared the code in service, if COPIER>Function>CLEAR>E355-CLR], press the OK key to clear it

Replace the set of Counter pcb & Serial pcb for E355

check the conection between counter pcb & monitor pcb for E350

This fix will have to go through Canon. They will have to get a serial number and then send you out a Main Controller and Serial Number PCB as a set. I had this happen to me one time



ŸáéTˆDÎÄ

ÏàêPÙYÁÏÑa³ä


ŸáéTêP×¢