huipCP5225打印機59.f0Error
更新時間：2025/7/21 23:05:40,view:125huipCP5225蘇州打印機售后服務(wù)中心客服熱線69616769，蘇州客服中心電話，打印機蘇州維修部，打印機蘇州廠家電話，
電機和齒輪組轉(zhuǎn)不動都會出現(xiàn)59.F0,蘇州惠普維修站電話696l6769
The sensor flag/lever is stuck in the up position which causes the 59.F0 error
59.F0 error ITB Contact Alienation error
Code 59.F0
Display
59.F0 ERROR
Description Transfer alienation failure
Remedy
1. Verify that the ITB is installed.
2. Reconnect the primary-transfer disengagement sensor J19, and connector J128 on the DC controller PCA .
3. Run the sensor test in the sensor monitor mode to verify that the primary transfer disengagement sensor is functioning properly. If not, replace the primary transfer disengagement sensor.
4. Perform the alienation drive component test in the DIAGNOSTICS menu. If not, replace the fuser motor.
The following are the steps to be performed to solve 59.F0 error code.
Step 1: Reseat ITB
The first step is to reseat the Intermediate Transfer Belt (ITB).
Step 2: Check Connection of sensor SR9.
Next check the connection to sensor SR9. This sensor controls the Primary Transfer Roller Disengagement and is connected at the Connector J19. Also check the connections to the DC controller.
Step 3: Manually check the ITB gear and Flag.
huipCP5225打印機59.f0Error
The sensor flag/lever is stuck in the up position which causes the 59.F0 error
59.F0 error ITB Contact Alienation error
Code 59.F0
Display
59.F0 ERROR
Description Transfer alienation failure
Remedy
1. Verify that the ITB is installed.
2. Reconnect the primary-transfer disengagement sensor J19, and connector J128 on the DC controller PCA .
3. Run the sensor test in the sensor monitor mode to verify that the primary transfer disengagement sensor is functioning properly. If not, replace the primary transfer disengagement sensor.
4. Perform the alienation drive component test in the DIAGNOSTICS menu. If not, replace the fuser motor.
The following are the steps to be performed to solve 59.F0 error code.
Step 1: Reseat ITB
The first step is to reseat the Intermediate Transfer Belt (ITB).
Step 2: Check Connection of sensor SR9.
Next check the connection to sensor SR9. This sensor controls the Primary Transfer Roller Disengagement and is connected at the Connector J19. Also check the connections to the DC controller.
Step 3: Manually check the ITB gear and Flag.
huipCP5225打印機59.f0Error
熱門圖文